Hi all,


I assume you could also use beading thread quite successfully.



Andrea,

Cambridge, UK - where the weather just can't make up its mind.

> To: [email protected]
> Date: Wed, 22 Jul 2009 17:01:19 -0400
> Subject: Re: [lace] spangle question
> From: [email protected]
>
> Hi all,
> When I did this a few years ago, someone on the list recommended
> using dental floss. Worked much easier than the wire. Load the floss
> with the beads... wrap it around the spot that you want the beads to go
> and then tie a nice square knot. I also threaded the ends through the
> beads both ways to hide the knot and to give it a bit more strength.
> So far, none of them have popped.
> Good luck!
> bobbi
>
> On Wed, 22 Jul 2009 16:46:08 -0400 Clay Blackwell
> <[email protected]> writes:
> > I also had several dozen of this type bobbin, and used the same wire
> > that I used to put spangles on Midlands bobbins. I used lots of
> > color
> > combinations (red and white were traditional Danish colors!) and
> > counted
> > out however many beads it took to cover the circumference. Then I
> > wrapped the beaded wire around the grove, twisted it a couple of
> > times,
> > and ran the two ends of wire in opposite directions through the
> > center
> > of the beads, which were now snugly in place. They brightened up
> > the
> > bobbins - and the pillow - quite nicely!
> >
> > Clay
> ____________________________________________________________
> Do it right the first time. Click to find contractors to work on your home
improvement project.
>
http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTJutoMrjXgrh4hBU0HS3jHxjILc
YcjC7vGY3cwAzkP40hMRt69pIU/
>
> -
> To unsubscribe send email to [email protected] containing the line:
> unsubscribe lace [email protected]. For help, write to
> [email protected]

_________________________________________________________________
Share your memories online with anyone you want.

-
To unsubscribe send email to [email protected] containing the line:
unsubscribe lace [email protected]. For help, write to
[email protected]

Reply via email to