Michael Li wrote: > Robert ??: > >> Thanks a lot, Michael. I downloaded ath driver, but my pkgadd could >> not go through successfully. Here is the output of >> "/usr/X11/bin/scanpci -v". >> >> >> pci bus 0x0003 cardnum 0x03 function 0x00: vendor 0x14e4 device 0x4318 >> Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN >> Controller CardVendor 0x1028 card 0x0005 (Dell, Card unknown) >> STATUS 0x0000 COMMAND 0x0106 >> CLASS 0x02 0x80 0x00 REVISION 0x02 >> BIST 0x00 HEADER 0x00 LATENCY 0x40 CACHE 0x00 >> BASE0 0xdfbfe000 addr 0xdfbfe000 MEM >> MAX_LAT 0x00 MIN_GNT 0x00 INT_PIN 0x01 INT_LINE 0x0a >> BYTE_0 0x01 BYTE_1 0x00 BYTE_2 0xc2 BYTE_3 0x07 >> >> >> This message posted from opensolaris.org >> _______________________________________________ >> laptop-discuss mailing list >> laptop-discuss at opensolaris.org >> >> > Hi, Robert, > > Your WLAN module is bcm4318, we have only ndiswrapper to support it on > solaris nevada build 54+, (32 bit kernel only). New ndiswrapper will > be uploaded to OpenSolaris/ndis page about next week. It bases on > GLDv3, need backport for s10 support. > Thanks, > > Michael > _______________________________________________ > laptop-discuss mailing list > laptop-discuss at opensolaris.org Hi, Robert,
I found below topic, it should be very helpful for bcm4318 + solaris 10 users. http://www.opensolaris.org/jive/thread.jspa?messageID=58479 Thanks for bung-foo's blog! Good luck, Michael
