and why are u ask this here?
try here:
http://www.squid-cache.org/mailing-lists.html
Tushar Gupta wrote:
Hi,
We are using squid for caching, with SCSI disk and 512 MB RAM. The
cache_mem setting in squid.conf is 64 MB. After running for several
hours total free RAM (as seen by top command) reduces to few kilobytes
and server response time increases (CPU idle cycles also go to zero),
and we need to reboot the server. Though as percentage of total CPU
usage squid is usually taking around 15-30%CPU and percentage of RAM as
12-15%MEM . After rebooting the server would again run fine for several
hours say half a day, and then RAM would gradually get consumed again.
Any suggestions are welcome.
Thanks
Tushar
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]
On Behalf Of Mathieu Deziel
Sent: Monday, January 27, 2003 7:33 PM
To: [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED]; [EMAIL PROTECTED]
Subject: RE: [LARTC] Bandwidth Restrictions in Linux
Hello
We are ISP and we give Internet Wireless Outdoor Service . The
Base Station
works in 802.11b and it is connected with a Linux Mandrake Server
that make
NAT.
802.11b devices are by design experiencing "hidden node" effect.
"Hidden node" problem can be avoided by the use of RTS-CTS (request to
send, clear to
send). RTS-CTS are optional but can be enabled. You can also specify a
threshold in
the size of the packet under which RTS-CTS will not be used, in which
case the hidden
node problem might occur for those packets. RTS-CTS will solve the
hidden node
problem, but will consume BW.
Mathieu.
_______________________________________________
LARTC mailing list / [EMAIL PROTECTED]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
