Hi! Can somebody tell what is the best way for load balancing with one ISP. Here is the scenario (there is a LAN behind the wireless clients):
linux wireless client--------\
---Access Point (Orinoco AP1000)----linux router----ISP
linux wireless client--------/
The two wireless clients are connected to the two different wireless interfaces of the Access Point.
They could be two PC's or one PC with two wi-fi cards (I don't think it matters). Since the configuration is in use now it is not recommended to make very long lasting experiments:).
The idea is to balance (increase) the speed for the PC's behind the wireless client(s). Single wireless client achieves 5Mbit/s, but is shaped to 4 Mbit/s since at 5Mbit there is big lag, so a PC in the LAN when using static routes can't use more than 4Mbit even the other channel is free.
I would probably use CBQ + [e]SFQ. You can define classes for both linux wireless clients on the linux router which borrow traffic between each other and use [e]SFQ to equal connection speed inside these classes; or the [e]SFQ part may run on the linux wireless clients
Has somebody some experience with similar configuration, and what is the best solution:
(t)eql, multipath routing, some variant of bonding, something else?
multipath routing ... where you find multipath routes on that picture ? bonding ... it's applied in
PC1 | NIC | - - - - - - - - | NIC | PC2
| NIC | - - - - - - - - | NIC |enviroment.
Is it at all possible to use bonding in such situation?
_______________________________________________ LARTC mailing list / [EMAIL PROTECTED] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________ LARTC mailing list / [EMAIL PROTECTED] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
