Matteo Brusa <[EMAIL PROTECTED]> writes:
> Hi,
> I have a typical configuration for my firewall/gateway box: single network
> card, with a pppoe connection to the DSL modem.
> I'm already successfully shaping the uplink (how come that the
> wondershaper.htb doesn't use the ceil parameter? It should implement bandwidth
> borrowing!) but i found the ingress policy a little bit rough.
> I'd like to keep the traffic categories i have in the uplink: ssh, web and batch.
> The goal is to discard packets of the lowest class first, then the middle, and so on.
> I've implemented a simmetrical downlink version of the uplink shaping on eth0,
> the other interface. However, i get this error (warning?) in the log:
> pppoe[29606]: send (sendPacket): No buffer space available
Hm, I just did exactly the same thing here. I don't see this.
What do your filters look like?
I do see
HTB: dequeue bug (8), report it please !
which I think is because i have too low burst/cburst settings.
My settings currently look like:
tc class add dev $DEV parent 1: classid 1:1 htb rate ${BW}kbit burst 8k cburst 8k
tc class add dev $DEV parent 1:1 classid 1:10 htb rate ${BW80}kbit ceil ${BW}kbit
burst 8k cburst 8k prio 1
tc class add dev $DEV parent 1:1 classid 1:20 htb rate ${BW10}kbit ceil ${BW}kbit
burst 4k cburst 1k prio 2
tc class add dev $DEV parent 1:1 classid 1:30 htb rate ${BW10}kbit ceil ${BW}kbit
burst 2k cburst 1k prio 3
(where ${BWxx} == xx% of the total bandwidth I want on that link)
--
greg
_______________________________________________
LARTC mailing list / [EMAIL PROTECTED]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
