Yes, the output is below:
eth0 Link encap:Ethernet HWaddr 00:11:09:2A:A6:F6
inet addr:10.0.0.50 Bcast:10.0.0.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4244867 errors:0 dropped:0 overruns:0 frame:0
TX packets:1306632 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3898905509 (3.6 GiB) TX bytes:1756030081 (1.6 GiB)
Interrupt:19
And from ethtool:
Settings for eth0:
Supported ports: [ MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised auto-negotiation: Yes
Speed: 1000Mb/s
Duplex: Full
Port: MII
PHYAD: 1
Transceiver: external
Auto-negotiation: on
Supports Wake-on: g
Wake-on: d
Link detected: yes
Thanks.
-Ryan Power
At 04:32 PM 9/14/2006, you wrote:
Hi,
could you check the mtu set on eth0 with an ifconfig?
I tried my own setup and it works fine...
Regards,
Eric Janz
Departamento de Sistemas
Grupo Barceló Viajes
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
