Two questions
1.) When you type tc class ls dev ethx
- Do you see that both ftp streams are flowing into their proper
class; 1:1, 1:3?
2.) Are you sending enough traffic to reach the point of congestion on
you link?
- If your not then it will service all the traffic at the same
rate.
Jon Flechsenhaar
Boeing WNW Team
Network Services
(714)-762-1231
202-E7
-----Original Message-----
From: Bob Puff [mailto:[EMAIL PROTECTED]
Sent: Sunday, February 18, 2007 3:32 PM
To: [email protected]
Subject: [LARTC] prio not seeming to work
Hello,
I am trying to mess with a prio type qdisc, and must be missing
something.
Here's my sample code:
tc qdisc add dev eth0 root handle 1: prio tc filter add dev eth0 parent
1:0 prio 1 protocol ip u32 \
match ip dst 208.0.0.0/8 flowid 1:1
tc filter add dev eth0 parent 1:0 prio 3 protocol ip u32 \
match ip dst 0.0.0.0/0 flowid 1:3
I would assume that any traffic going to 208.x.x.x should be getting
priority over all other traffic. But when I set up two simultaneous FTP
uploads, one to a server in the 208.x.x.x block and one to another not
in that block, both end up at the same transfer rate.. This is going
into an ADSL line.
What am I missing?
Bob
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
