Thanks Grant, I am very new to combining NATing and Brigdge. Please can you possibly give an example on how to add the virtual interface.
Current /etc/networking/interfaces looks like this: --------------------------------------- auto lo iface lo inet loopback auto br0 iface br0 inet static address xxx.xxx.xxx.xxx netmask 255.255.255.128 network xxx.xxx.xxx.xxx broadcast xxx.xxx.xxx.xxx gateway xxx.xxx.xxx.xxx pre-up /sbin/ip link set eth0 up pre-up /sbin/ip link set eth1 up pre-up /usr/sbin/brctl addbr br0 pre-up /usr/sbin/brctl addif br0 eth0 pre-up /usr/sbin/brctl addif br0 eth1 ----------------------------------------- Kind Regards William Bohannan -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Grant Taylor Sent: Monday, May 28, 2007 6:39 PM To: Mail List - Linux Advanced Routing and Traffic Control Subject: Re: [LARTC] 2 NICs Bridge + Router On 5/28/2007 8:12 AM, William Bohannan wrote: > Hi wondering if anyone can help. I have two NICs on a debian sarge based > system and current running as a bridge (br0) which consists of eth0 and > eth1. Is it possible to add a virtual interface to the eth1 so I can > also do NAT on the box as well? I have tried many times and keep coming > up with errors. Why not add virtual aliased interfaces to the br0 interface? Do your NATing there. Grant. . . . _______________________________________________ LARTC mailing list [email protected] http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc _______________________________________________ LARTC mailing list [email protected] http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
