Hello there. I am setting up a router using openwrt. Part of the project is load balancing among 2 broadband lines. I made use of the line:
ip route add default scope global \
nexthop {GW1} dev {IF1} weight 1 \
nexthop {GW2} dev {IF2} weight 1
somewhere on the configs.
On the test phase, automatically switching (routing) to line GW2 when
line GW1 is suddenly disconnected takes a long time. I'm thinking that
the routing still tries to send to GW1 even though it's dead.
a. Is there a way around this?
b. Does routing react differently to carrier loss (unplugging the cable)
to a fully loaded line?
Any thoughts? Thanks...
--
Alec Joseph Rivera
F S 3 Consulting Inc.
http://www.fs3.ph
signature.asc
Description: This is a digitally signed message part
_______________________________________________ LARTC mailing list [email protected] http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
