That advice was valid in the pre-MSI era. Nowadays you need to follow the instructions at
http://digital.ni.com/public.nsf/3efedde4322fef19862567740067f3cc/940218c862 75330a86256bba0074780e?OpenDocument And those are anything but simple instructions. If all you need VISA for is serial and you are amongst the privileged group that have upgraded to LV7, then stick to following Rolf's advice from one of the previous messages: > In LabVIEW 7 Application Builder go to the Installer Settings > Tab->Advanced Button and select Serial Port Support. This > includes a minimal version of NI-VISA for serial support. No > MAX is installed though. Mihai Costache Senior Research & Development Engineer Industrial Research Ltd. Brooke House 24 Balfour Rd., Parnell PO Box 2225 Auckland, New Zealand DDI: +64 - 9 - 920 3645 Fax: +64 - 9 - 920 3106 www.irl.cri.nz **************************************************************************** **** Men stumble over the truth from time to time, but most pick themselves up and hurry off as if nothing happened. Sir Winston Churchill (1874-1965) **************************************************************************** **** > Subject: Re: NI-VISA Serial > From: "Paul F. Sullivan" <[EMAIL PROTECTED]> > Date: Thu, 6 May 2004 07:39:38 -0400 > > Stanley Kieta asked: > > >1. Is there an easy way to include VISA with the > >Application Installer so the user only needs to > >run 1 install program? > > > From my library of forum snippets, it appears > that Mihai Costache is the expert in question 1 > with two postings
