On 05/30/2018 10:42 AM, Joost van der Sluis via Lazarus wrote:
Op 30-05-18 om 16:24 schreef Donald Ziesig via Lazarus:
I have been developing database apps for years and I have finally
reached my limit. Occasionally I get exceptions in the db code but
the Call Stack is truncated as is shown below. I usually just "bite
the bullet" and single step through the code till I find the
offending line. This time, I got an exception after 8 hours of
execution. Is there any way that I can set this up so that I get a
location in my own code?
You could try to install the LazDebuggerFP package, and switch to the
FPDebug debugger in your debugger-options. In a lot of cases it shows
a more complete callstack.
And did you already tried to use the fcl-db package with debug-info?
If you want to, go to a terminal, change to current directory to the
fcl-db source (where the fpmake.pp file is). Then do:
fppkg install -o -gl
Then build your application in Lazarus, and you will have fcl-db with
debug-info.
Regards,
Joost.
Hi Joost!
Thanks for the quick response.
I found the fpmake.pp file in /usr/share/fpcsrc/3.0.4/packages/fcl-db.
Using sudo -i, I ran:
fppkg install -o -gl
It responded "Error code 301", then "Compile successful".
I ran it again:
hp-laptop fcl-db # fppkg install -o -gl
Warning: Unexpected response status code: 301
The FPC Package tool encountered the following error:
Found broken packages, run "fppkg fixbroken" first
hp-laptop fcl-db # fppkg fixbroken
Warning: Unexpected response status code: 301
Re-install packages which are dependent on just installed packages
The FPC Package tool encountered the following error:
Stream read error
All google searches for error 301 showed "Moved permanently" as the
meaning. Unfortunately, it doesn't show where it was looking when it
got the 301 error. Any suggestions?
Don
--
_______________________________________________
Lazarus mailing list
[email protected]
https://lists.lazarus-ide.org/listinfo/lazarus
