Le 19/12/2011 16:28, Martin a écrit :
The first thing to note is the breakpoint number -20
This means this is an gdb internal breakpoint, used in single
stepping. (so the ide has little influence here)
Either something went corrupt in gdb or the debug info (for the code
for which gdb tried to set the breakpoint ) is wrong
(does it work with fpc 2.5.1, afaik there were fixes)
You should be aware that this error screen appears with EVERY new
Lazarus installation whatever the build could be. This means fpc 2.4.4
and 2.5.1. I decided as welle to re-install my very last stable
2011-07-26 and the error is ALWAYS shown whether I use F7 or F8 after
the debugger stops on a breakpoint. I relaize that I din't mention all
steps:
1. build the project
2. set breakpoints
3. launch the programs within the IDE (F9)
4. the debuggers stops on the firs breakpoint. So far so good.
5. hit F7 (step into) :the debugger DOES nothing: nothing happens in any
way.
6. hit F7 again: popup error message
7. same behaviour for all programs, for all Lazarus versions
I begin to suspect Vista once again.
Remember, on Win server 2003 64 bit
- what was the last you did? step over/into/out? run?
- the content of the "debug output" window?
- gdb version?
no output
Though most likely there will not be much useful info..
right
--
_______________________________________________
Lazarus mailing list
[email protected]
http://lists.lazarus.freepascal.org/mailman/listinfo/lazarus
