I check few thinks and I think problem is in the TNotebook. Where I don't use this design mode works ok.
Dnia 01-10-2005, sob o godzinie 17:04 +0200, Michał Wojtaszek napisał(a): > Dnia 01-10-2005, sob o godzinie 11:08 +0200, Mattias Gaertner > napisał(a): > > On Sat, 01 Oct 2005 01:09:34 +0200 > > Micha__ Wojtaszek <[EMAIL PROTECTED]> wrote: > > > > > Hello > > > I have strange problem (as always :)) > > > When I place visible element on form it not show up in form editor. > > > > What type of control? > > > > > Any type of control (I try buton, dbgrid, panel and label). In some > cases control is drawn as gray rectangle.Also in some cases there is no > grid on element where I try place new element (I mean panel without > place grid). > > > > I > > > can select it by clik on place when is should by, i can change its > > > property in property manager and finally it display correct when I run a > > > project. Dis is not big project about ten form and one and half- two > > > hundreds elements. In design mode it is invisible. I close the project, > > > open new, place some elements on form and it is correct. But when I open > > > my main project problem returns. > > > > > > Latest svn > > > WinXP SP2 > > > FPC 2.0.1 > > > > > > Mattias > > > > _________________________________________________________________ > > To unsubscribe: mail [EMAIL PROTECTED] with > > "unsubscribe" as the Subject > > archives at http://www.lazarus.freepascal.org/mailarchives > > > > _________________________________________________________________ > To unsubscribe: mail [EMAIL PROTECTED] with > "unsubscribe" as the Subject > archives at http://www.lazarus.freepascal.org/mailarchives > _________________________________________________________________ To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe" as the Subject archives at http://www.lazarus.freepascal.org/mailarchives
