Subject was: [leaf-user] SST-DoM experiment On Fri, 2002-08-30 at 03:25, S Mohan wrote: > Dear Mike/Lynn/Brad: > > I soldered a jumper on my SST DoM. I expected it to give me a mounted as > readonly filesystem message when it is mounted. It did not. I saved a file > to that fs by piping output of ls to a file. That also went thro'. I was > puzzled. I then tried an explicit sync - Module reported an error > > No DRQ after issuing write. > Status error status=0x51 (DriveReady SeekComplete error) > Status error status=0x04 (DriveStatusError) > > This make the drive read only but looks convoluted. Does it not? > > I removed the jumper and did a sync, it went thro' smoothly. > > I expected the system to report readonly at mount time like it does for > write-protect floppies.
S Mohan, How did you solder the two ends of R8? What did the connection/jumper look like? Which pins on the ATA controller and IDE interface did you connect to? -- Mike Noyes <[EMAIL PROTECTED]> http://sourceforge.net/users/mhnoyes/ http://leaf-project.org/ ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 _______________________________________________ Leaf-hardware mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-hardware
