I have RoadRunner and I am not required to send a user name as Simon suggested. I assume your RoadRunner connection was working before you tried Dachstein. Are you using the same ethernet card to connect to your cablemodem as before? The ethernet card you use must be "registered" with RoadRunner first. Simply resetting the cablemodem doesn't seem to work (atleast not for myself). If you aren't using the original ethernet card, either try switching cards around or call RoadRunner and tell them the MAC address of the new ethernet card.
-todd prabhakar wrote: > > All: > > I am trying to use the Dachstein RC1 to setup a > floppy based firewall. I have > two NICs. Both are Intel eepro cards. eth0 is an > interface to the RR > cablemodem service, while eth1 is internal. I have > been unable to get the eth0 > to configure itself using DHCP from the roadrunner > service. It sends out a > DHCPDISCOVER for a while and then gives up. Both the > network cards are > recognized without a problem. I have tried several > things as suggested in the > archives: > 1. Use a different NIC to see if it is an eepro > problem. Had the same issue > with the other one too (a 3c905). > 2. Powered down the cablemodem to force it to > release any MAC address that it > might be storing. > > I am not sure what else I can do. Has anyone else > seen this problem. I have > looked through the archives, but haven't really > found anything useful. > Any info really appreciated. > > thanks > prabhakar __________________________________________________ Do You Yahoo!? Make a great connection at Yahoo! Personals. http://personals.yahoo.com _______________________________________________ Leaf-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user
