OK. I can't help you much, but I'll say the little I can and leave it for someone more appropriate to suggest the fix.
Your problem is that the tulip module cannot fins the Linksys card. The message you report getting -- >-->tulip: init_module:tulip: device or resource busy -- is the one the module issues when it cannot find the NIC it is designed to drive. (Not the best phrasing of that error, but it's been used for years, so we all get used to it.) Your problem, as you surmised, is that you need to load the appropriate pcmcia modules first. That's the part theat someone else has to help with, as I've never tried to use any version of LEAF with a pcmcia device. Until you get this part rght, don't bother messing with later configuration. This failure generates later errors, which will fix themselves once you get the NIC initialized properly. At 05:35 AM 1/18/02 +0000, malik menzong wrote: >I am sorry ray and others for the vagueness of my request. And I do >appreciate your willingness to share your knowledge and expertise: >here is the problem: >I want to build a lrp disk for my laptop. I am using cable dsl >what I have done: >I downloaded the dachsteinv1.0.2-1680 based on kernel 2.2.19 >I decided to get an extra linksys 10/100 PC card, model:pcmpc100 . so I am >planning on using 2 linksys card for internal and external link. > >while following the instruction in the readme file I descovered that I >needed to add some modules if I wanted this to succeed. while reading >mailing list I found out that linksys driver are compatible with 'tulip'. >and since tulip was on the floppy disk i was one step closer to success. >>From someone more knowledgeable than me I was told the following and I >quote: >"the pcmcia support comes in multiple modules: pcmcia-core, the module for >your card-bridge, and the modules for each card you might insert." So I >decided to look for those 3 modules too. i have not find them, yet. >but I went ahead and tried it to load the floppy disk anyway: > 1)I removed the # sign for the tulip module > 2)I backed up what I have done and rebooted my system. > >what error i got: >-->tulip: init_module:tulip: device or resource busy >-->No subnet declaration for eth1(0.0.0) Please write a subnet declaration >dhcp.conf > >So I could not complete the operation. If you find my mistakes here and >things/steps I need to take to complete this task let me know. Again sorry >for not being specific. -- ------------------------------------"Never tell me the odds!"--- Ray Olszewski -- Han Solo Palo Alto, CA [EMAIL PROTECTED] ---------------------------------------------------------------- _______________________________________________ Leaf-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user
