> Hi, folks- > Here is a thoroughly documented dumb situation. I cannot get eth0 up. (Even > though I did it before on this machne!) I am pretty sure that the answer is > obvious, but _I_ do not see it! > I am running Dachstein floppy with a static IP over ISDN. > Here are the documentation tidbits & network.conf. First is a lot of info > from the non-working version, then a little peek at the old, working setup... > > ***FROM NEW, NOT WORKING BOOT MESSAGES: > Starting Network: [IP Always Defrag: ENABLED] > IP filters: firewall [IP Forwardsing: ENABLED] > Loopback Interface: lo > Starting interface: Error: an inet prefix is expected rather than > "216.83.107.242/". > RTNETLINK answers: Network is unreachable > eth0 eth1: Setting full-duplex based on MII #1 link partner capability of 45e1.
A simple problem... > eth0_IPADDR=216.83.107.242 > eth0_MASKLE=24 Try: eth0_MASKLEN=24 NOTE: Looks like you accidentally hacked the "N" off MASKLEN, causing your problem... Charles Steinkuehler http://lrp.steinkuehler.net http://c0wz.steinkuehler.net (lrp.c0wz.com mirror) _______________________________________________ Leaf-user mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user
