Hi,
> I try to find mrouted becouse this support other protocols than PIM.
> I have others cisco router. The problem is: if this PIM sparse module can
> interact with the router cisco serie 2500.
No problem, I get my multicast feed from a Cisco 2600 series router. Just
configure each interface for pim-sm, like this:
Cisco#configure terminal
Cisco(config)#ip pim sparse-mode
Cisco(config)#ip pim rp-address <IP address of your rendevous point>
Cisco(config)#interface ethernet 0/0
Cisco(config-if)#ip pim sparse-mode
(Repeat this for other interfaces that run pim-sm).
> If yes, I thanks to you if you can compile and make the lrp package pimd.lrp
> for me.
I'll send you my home grown pimd.lrp as well as an mrouted.lrp package I
downloaded somewhere, in private communication. I hope it works out for you.
Use mrouted for DVMRP and pimd for PIM-SM.
Regards,
-Dan
_________________________________________________________________
Dan M�nster, PhD E-mail: [EMAIL PROTECTED]
UNI�C, Research Phone: (+45) 8937 6621
Olof Palmes All� 38 Fax: (+45) 8937 6677
DK-8200 �rhus N, Denmark WWW: http://www.uni-c.dk
_________________________________________________________________
_______________________________________________
Leaf-user mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
