wisp-dist build 2312 I have loaded the 2312 flash image on the new TT board and also on the Soekris board. I am using the new 100mW higher power card.
They pass traffic in infrastructure / client mode but not in AP mode. If I use station- server or TT firmware for AP, the wisp-dist client works but not in AP mode. I have seen it mentioned it may have something to do with the new pcmcia controller on these two boards. I am not sure. Any ideas / help / suggestions? Also, the RSSI reading in client mode just sits at 100% whether connected or not. I figure this is a problem with the driver talking to the card. -- jjeeffff rrhhuuee ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
