Hi folks, I trying to set up a new box using the new Bering 1.04, and I'm using a Linksys LNE100TX and a 3Com 3C595-TX. My IP address is assigned dynamically to me by my ISP (I have AT&T Broadband), and I'm trying to use DHCP for my LAN. Here's what I have done:
1.) Uncommented the appropriate drivers. When Bering boots - I see: Loading modules: tulip - 3c59x - Using /lib/modules/3c59x.o 2.) Edited the syslinux.cfg file, and added the dhcpd entry. 3.) Edited the /etc/shorewall/interfaces file and added the "dhcp" entry (without the quotes, of course) on the eth1 line under the OPTIONS category. As Bering boots, when it get to the point where it says "Configuring network interfaces" I see the error message...Operation not supported by device, and then as Bering finishes booting, I see a Device "eth1" does not exist error message. When Bering finally boots, I typed ps ax and I see: pump -i eth0, but I don't see any reference to dhcpd or eth1. Suggestions??? Craig ------------------------------------------------------- This sf.net email is sponsored by: Influence the future of Java(TM) technology. Join the Java Community Process(SM) (JCP(SM)) program now. http://ads.sourceforge.net/cgi-bin/redirect.pl?sunm0004en ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
