[leaf-user] restoring vlan's after reboot: /proc/net/vlan not there

[Scott]

using Intel Pro/100 82559 chipset
using eepro100 Revision 1.36
using bering rc4

On boot I'm getting the error:
SIOCGIFFLAGS: Operation not supported by device

I load the 802.1q driver (8021q.o). I configure my vlan with the following command lines:

vconfig add eth1 11
vconfig add eth2 12
vconfig add eth3 13
etc...

I backup the vlan. When I reboot, it is not finding the devices eth1.11, eth1.12, and eth1.13. I check /proc/net/vlan and it's empty where there used to be entries for each virtual device.

/var/lib/lrpkg/vlan.list:

sbin/vconfig
etc/network/if-pre-up.d/vlan
etc/network/ip-up.d/ip
etc/network/if-post-down.d/vlan
var/lib/lrpkg/vlan.*

By default there is no entry in vlan.list for /proc/net/vlan. I tried adding it, but it bombs when I try "lrpkg -i vlan" later with a tar error. Any suggestions how to have those vlans active when I boot? Otherwise shorewall doesn't have anything to configure.

-Scott




-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf
------------------------------------------------------------------------
leaf-user mailing list: [EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-user
SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html