Hi Troy, Thanks for this, I think my main problem was that I did not include the ||true at the end of each line. It seems that you need this for multi line statements.
Regards, Simon. -----Original Message----- From: Troy Aden [mailto:[EMAIL PROTECTED] Sent: 29 September 2003 16:22 To: 'Simon Chalk'; Leaf-User List Subject: RE: [leaf-user] Routing for multiple uplinks for Bering 1.2- More Info [faked-from][sls] Here is what I have done on our Bering routers to add routes. up ip route add 192.168. *.*/24 via 192.168.*.* || true up ip route add 192.168. *.*/24 via 192.168. *.* || true up ip route add 192.168. *.*/24 via 192.168. *.* || true up ip route add 192.168. *.*/24 via 192.168. *.* || true Hope this helps. Troy -----Original Message----- From: Simon Chalk [mailto:[EMAIL PROTECTED] Sent: Monday, September 29, 2003 8:39 AM To: Leaf-User List Subject: [leaf-user] Routing for multiple uplinks for Bering 1.2- More Info [faked-from][sls] Hi All, Further to my first post. I am adding all the ip route commands to /etc/network/interfaces using up ip route etc.etc up ip rule add etc.etc It appears that not all the commands are been loaded. I think it is the ip rule add bit. So my question is should I be using a different file, or is my syntax wrong. Am I correct to prefix each command with up. Regards, Simon. -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Simon Chalk Sent: 29 September 2003 13:18 To: Leaf-User List Subject: [leaf-user] Routing for multiple uplinks for Bering 1.2 Hi All, I am trying to implement the split access configuration which will allow my Bering 1.2 box to correctly route to two ISP's as described on the LARTC site. http://lartc.org/howto/lartc.rpdb.multiple-links.html I have created two new entries in the /etc/iproute2/rt_tables file and followed the instructions. It appears not to be working, and the first thing I note is that I don't see my new tables listed when I enter ip rule show I only see the default entries. Should I see these tables listed? Should I be able to configure this in Bering, or do I need to enable some other setting before attempting to follow the instructions. Regards, Simon. ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html