pcnet_cs depends on pcmcia_core.o
ds.o and 8390.o
please try this modules. This informations is from the modules.dep file (not tested)
All this is given. I had a look into the modules.dep too ;-) I found two versions of 8390.o in the modules.tgz. I tried both... Currently I have no problems anymore to load pcnet_cs.o.
But the device eth0 is not running.
ifup -a (typed.first.time) reports "operation not supported" (or.some.thing.similar) ifup -a (typed.second.time) reports "Device already configured"
Funny. ip link set eth0 up address 1.1.1.1 reports "Operation not supported"
my /etc/network/interfaces for eth0:
---------------------------- snip
auto eth0
iface eth0 inet static
address 192.168.1.1
masklen 24
broadcast 192.168.1.255
---------------------------- snap"ip link show" always only has its own io and loopback device.
Question: Should not the devicedriver have *some* output, if it loads its device ?
pcnet_cs does not say anything (console,messages..nothing)
when it loads.
Thanks for your time !
------------------------------------------------------- The SF.Net email is sponsored by EclipseCon 2004 Premiere Conference on Open Tools Development and Integration See the breadth of Eclipse activity. February 3-5 in Anaheim, CA. http://www.eclipsecon.org/osdn ------------------------------------------------------------------------ leaf-user mailing list: [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/leaf-user SR FAQ: http://leaf-project.org/pub/doc/docmanager/docid_1891.html
