Hello Jeremy, > >> There are a few ways to setup madwifi, you can set autocreate to none >> in /etc/modules like this: >> ... >> ath_pci autocreate=none > > If I add anything after my module name save my changes and reboot my ath0 > interface doesn't come up. I checked this by doing - ip -s addr and could > see the wif0 and ath0 interfaces were missing. Also, shorwall masq > complains - unable to determine the route through ath0. (Which I would > expect if the interface doesn't exist). I also tried your other > suggestions below with no luck.
That's very strange... It looks like your card is still not fully supported... But I just saw on the madwifi page that they updated the HAL with more cards supported. If you like I can compile the latest modules and userspace tools, send me a mail offlist and I'll send them to you. > > It would seem this is the only to make this work. (by leaving just plain > ath_pci in /etc/modules) Will I actually see mode "AP if I look at > iwconfig or will I see "Master"? > You will see "mode:Master" > I also thought maybe I should disable the auto up/down scripts for the > madwifi portion and manually type the commands to see what happens. > It's a good test to insmod the right modules by hand and use the wlanconfig tools, maybe you see some more messages... But if you think the compatibility may be a problem, don't bother and send me a mail for the latest drivers. Eric ------------------------------------------------------- This SF.net email is sponsored by: Splunk Inc. Do you grep through log files for problems? Stop! Download the new AJAX search engine that makes searching your log files as easy as surfing the web. DOWNLOAD SPLUNK! http://sel.as-us.falkag.net/sel?cmd=lnk&kid=103432&bid=230486&dat=121642 ------------------------------------------------------------------------ leaf-user mailing list: [email protected] https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/
