I've got coreboot version 20160307. According to the PC Engines website this introduces SD boot support. There is a 20160311 version so I may try that.
John On 18/01/17 15:40, kp kirchdoerfer wrote: > Hi John; > > Am Mittwoch, 18. Januar 2017, 09:41:26 schrieb John Sager: >> For some years I've run leaf-bering on a PC Engines Alix 2D13 board as my >> main router, but now I need to upgrade to a board that supports gigabit >> ethernet, vlans, baby jumbo frames, etc. >> >> The apu2c2 board has 3 gigabit LAN ports, 2 USB3 ports, SD card reader plus >> mSATA & PCI express sockets. > >> Using Bering-uClibc_6.0.2-rc1_x86_64_syslinux_serial115200.tar.gz on a USB >> stick the board boots fine. However I can't get it to boot from a SD card. >> The bios boot (coreboot) recognises the SD card in the boot list but then >> hangs at the point where it should transfer to syslinux. This is obviously a >> PC Engines issue and not one for Leaf. There is a thread about this on PC >> Engines' forum: >> >> http://pcengines.info/forums/?page=post&id=1532182F-D982-4735-A4BF-7E786EC42 >> 179 > > Do you even have installed a BIOS with SD support? > I've got one of the earlier borads with an older BIOS and had to update to > 160211 to get the wlee200nx to work, works fine with mSATA. I've updated > later > the kernel because a user had a SD card with support for the SD card, but > AFAIR got no feedback since. > > But it seems, following the thredad above SD issus might not be solved > finally > ...? > > kp > >> However the recommendation seems to be to use a mSATA card instead:( >> >> If I go down that route though that brings up another problem - the apu2c2 >> is the only mSATA interface I have available, and the tools required to >> transfer the working config from the USB stick to mSATA (fdisk, mkfs.vfat, >> syslinux) don't seem to be available in any of the Leaf packages. I would >> probably have to boot up TinyCore Linux temporarily to do the transfer. >> >> Having transferred the appropriate (5.2.4) configs from the old router, I >> have run into module loading problems - see my next e-mail for a discussion >> of this. >> >> regards, >> >> John Sager >> >> ---------------------------------------------------------------------------- >> -- Check out the vibrant tech community on one of the world's most >> engaging tech sites, SlashDot.org! http://sdm.link/slashdot >> ------------------------------------------------------------------------ >> leaf-user mailing list: leaf-user@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/leaf-user >> Support Request -- http://leaf-project.org/ > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > ------------------------------------------------------------------------ > leaf-user mailing list: leaf-user@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/leaf-user > Support Request -- http://leaf-project.org/ > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot ------------------------------------------------------------------------ leaf-user mailing list: leaf-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/leaf-user Support Request -- http://leaf-project.org/