Dear readers,
A similar question is already posted somewhere before, but not answered as
far as I can tell.
The problem is associating to the wdist AP. Clients are unable to associate
to the AP from binary build 2624. On the other hand everything works like a
charm when I configure wdist in ad-hoc mode. Wouldn't it be nice if I was
happy with ad-hoc mode... I know the card can work in AP-mode because it
does on a full installation of mandrake 9.1
If someone could help me to find the problem that would really be
appreciated.
[Some more information]
Wireless PCMCIA card: NL-2511CD PLUS EXT2
iwconfig:
netcs1 IEEE 802.11-DS ESSID:"wesp" Nickname:"AP"
Mode:Master Frequency:2.417GHz Access Point: 00:02:6F:05:4A:37
Bit Rate:2Mb/s Tx-Power:-23 dBm Sensitivity=1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:1122-33AA-BB Encryption mode:open
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Changed the following configuration files
----
/etc/pcmcia/hostap_cs.conf
* module "hostap_cs" opts "ignore_cis_vcc=1"
/etc/default/pcmcia
* PCIC_OPTS="irq_mode=0 pci_csc=0 poll_interval=100"
/etc/pcmcia/config.opts
* include port 0xc000-oxcfff
----
Best regards,
Mark van der Putten
Intemo BV.
Marshallstraat 24
5705 CN Helmond
Brabant, the Netherlands
-------------------------------------------------------
This SF.Net email sponsored by Black Hat Briefings & Training.
Attend Black Hat Briefings & Training, Las Vegas July 24-29 -
digital self defense, top technical experts, no vendor pitches,
unmatched networking opportunities. Visit www.blackhat.com
_______________________________________________
leaf-wisp-dist mailing list
[EMAIL PROTECTED]
https://lists.sourceforge.net/lists/listinfo/leaf-wisp-dist
