Howdy,
Anybody on leapsecs know about this WWVB format change from 2012? I have no
memory of discussing this from the time, and I’m not finding anything searching
the message stream. No answer yet from Time-nuts. Is this so well known that my
question seems naive, or rather, was this change implemented with insufficient
notice even to the folks on these two lists?
There’s also the section “Enhanced WWVB Broadcast Format Change” here:
http://www.nist.gov/pml/div688/grp40/wwvb.cfm
<http://www.nist.gov/pml/div688/grp40/wwvb.cfm>
There’s an excellent history of WWV[B|H]:
http://tf.nist.gov/general/pdf/1969.pdf
<http://tf.nist.gov/general/pdf/1969.pdf>
Which indicates (p.30) that Datum 9100-series time code generators from the
1970s were still being used as of 2005 in creating the WWVB signal.
Rob
—
Here’s another: http://www.nist.gov/pml/div688/grp40/upload/Bin-2719.pdf
<http://www.nist.gov/pml/div688/grp40/upload/Bin-2719.pdf> – I most definitely
would not have been paying any attention to WWVB issues during May 2014.
> Begin forwarded message:
>
> From: Rob Seaman <[email protected]>
> Subject: Kinemetrics/Truetime WWVB model 60-dc?
> Date: April 29, 2016 at 4:12:57 PM MST
> To: Discussion of precise time and frequency measurement <[email protected]>
>
> Howdy,
>
> We’re in the process of upgrading our telescopes in various ways, including
> deploying spiffy new GNSS clocks. While rummaging around the shelves of old
> equipment, I came across the WWVB time code generators that had been retired
> themselves a dozen years ago or more (in favor of NTP and/or GPS equipment).
> These are Kinemetrics/Truetime model 60-dc. They appears to power up ok to
> the point of displaying the colons and flickering keep-alive LEDs (see p.51
> of http://www.to-way.com/tf/60dc.pdf). It would be cool to bring them back to
> life, if only to serve as retro wall clocks.
>
> It turns out the old 60 KHz antenna (same manufacturer, model A-60FS) was
> still mounted on the building, but I wasn’t able to get either of the two
> devices to lock when connected to it. The antenna had been repaired at some
> point, so I have no confidence that it's still in working condition after
> many years out in the weather after the case had been opened.
>
> Now I’ve come across this notice from Spectracom:
>
>
> http://spectracom.com/sites/default/files/document-files/Pending%20Changes%20in%20the%20WWVB%20Radio%20Signal%20Affects%20Precision%20Frequency%20and%20Timing%20Reference.pdf
>
> which suggests that other vendors’ devices might also "no longer operate as
> intended as a result of the WWVB signal change” after July 2012.
>
> If so, bummer!
>
> If not, suggestions for acquiring a functioning antenna?
>
> Many thanks for any information on these or similar devices. I should note
> that another telescope elsewhere on the mountain appears to still be using a
> Datum model 9100 (via Forth software!) nightly (though with WWV, not WWVB?)*
> Does anybody have a manual for that unit?
>
> Rob Seaman
> University of Arizona
> —
> * there were even some IRIG wall clocks
_______________________________________________
LEAPSECS mailing list
[email protected]
https://pairlist6.pair.net/mailman/listinfo/leapsecs
