Hi, You may want to flash back to factory and flash to LEDE via *-factory.bin. Make sure to set all configurations by hand. Best Regards, Syrone Wong
On Thu, Jul 14, 2016 at 8:48 PM, Florian Eckert <eckert.flor...@googlemail.com> wrote: > Hello LEDE-Team > > I am using a openwrt 15.05 on an lantiq xrx200 device. > Upgrade works always as expectet for 15.05. > I am using the squashfs tar file. > > I wantet to test lede and i have seen that the image generation has > completly changed there is no tar file anymore only bin. > If i use this to make a sysupgrade command i always get the output > > Could not open mtd device: firmware > Can't open device for writing! > Upgrade completed > Rebooting system... > > In openwrt i always could untar the tar file. To see the structur CONTROL ... > In lede this does not work anymore. > > What to i make wrong? Could you explain your changes? > > Regards Flo > > _______________________________________________ > Lede-dev mailing list > Lede-dev@lists.infradead.org > http://lists.infradead.org/mailman/listinfo/lede-dev _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev