Just built LEDE from latest source and get a jffs2 error on the Ubiquiti UAP-PRO. The errors continue on down the screen for several pages before the device crashes and reboots again in a loop. Openwrt doesn't have this problem.
Gareth [ 0.000000] Linux version 4.4.19 (xxxxxxx@xxxxxxx) (gcc version 5.4.0 (LEDE GCC 5.4.0 xxxxxxx) ) #0 Sun Aug 28 02:04:23 2016 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 0001974c (MIPS 74Kc) [ 0.000000] SoC: Atheros AR9344 rev 3 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 08000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] No valid device tree found, continuing without [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000007ffffff] [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32512 [ 0.000000] Kernel command line: board=UAP-PRO mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,1536k(kernel),14208k(rootfs ),256k(cfg)ro,64k(EEPROM)ro,15744k@0x50000(firmware) console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 512 (order: -1, 2048 bytes) [ 0.000000] Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) [ 0.000000] Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 125140K/131072K available (2974K kernel code, 154K rwdata, 748K rodata, 276K init, 200K bss, 5932K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Clocks: CPU:560.000MHz, DDR:450.000MHz, AHB:225.000MHz, Ref:40.000MHz [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 6825930166 ns [ 0.000009] sched_clock: 32 bits at 280MHz, resolution 3ns, wraps every 7669584382ns [ 0.008292] Calibrating delay loop... 278.93 BogoMIPS (lpj=1394688) [ 0.081138] pid_max: default: 32768 minimum: 301 [ 0.086170] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.093224] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.103117] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.114303] NET: Registered protocol family 16 [ 0.120407] MIPS: machine is Ubiquiti UniFi AP Pro [ 0.128816] registering PCI controller with io_map_base unset [ 0.354243] PCI host bridge to bus 0000:00 [ 0.358656] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff] [ 0.365972] pci_bus 0000:00: root bus resource [io 0x0000] [ 0.371919] pci_bus 0000:00: root bus resource [??? 0x00000000 flags 0x0] [ 0.379144] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff] [ 0.387662] pci 0000:00:00.0: invalid calibration data [ 0.393573] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1001ffff 64bit] [ 0.401410] pci 0000:00:00.0: BAR 6: assigned [mem 0x10020000-0x1002ffff pref] [ 0.409107] pci 0000:00:00.0: using irq 40 for pin 1 [ 0.415233] clocksource: Switched to clocksource MIPS [ 0.421868] NET: Registered protocol family 2 [ 0.427353] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.434782] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.441590] TCP: Hash tables configured (established 1024 bind 1024) [ 0.448447] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.454667] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.461622] NET: Registered protocol family 1 [ 0.470520] futex hash table entries: 256 (order: -1, 3072 bytes) [ 0.477161] Crashlog allocated RAM at address 0x3f00000 [ 0.496159] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.502374] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.515344] io scheduler noop registered [ 0.519526] io scheduler deadline registered (default) [ 0.525210] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 0.532430] console [ttyS0] disabled [ 0.556327] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 2500000) is a 16550A [ 0.565519] console [ttyS0] enabled [ 0.565519] console [ttyS0] enabled [ 0.572933] bootconsole [early0] disabled [ 0.572933] bootconsole [early0] disabled [ 0.584480] m25p80 spi0.0: found mx25l12805d, expected m25p80 [ 0.590396] m25p80 spi0.0: mx25l12805d (16384 Kbytes) [ 0.595570] 7 cmdlinepart partitions found on MTD device spi0.0 [ 0.601569] Creating 7 MTD partitions on "spi0.0": [ 0.606448] 0x000000000000-0x000000040000 : "u-boot" [ 0.613572] 0x000000040000-0x000000050000 : "u-boot-env" [ 0.620596] 0x000000050000-0x0000001d0000 : "kernel" [ 0.627238] 0x0000001d0000-0x000000fb0000 : "rootfs" [ 0.633805] mtd: device 3 (rootfs) set to be root filesystem [ 0.639654] mtdsplit: no squashfs found in "rootfs" [ 0.644620] 0x000000fb0000-0x000000ff0000 : "cfg" [ 0.650975] 0x000000ff0000-0x000001000000 : "EEPROM" [ 0.657644] 0x000000050000-0x000000fb0000 : "firmware" [ 0.674206] switch0: Atheros AR8327 rev. 4 switch registered on ag71xx-mdio.0 [ 0.732303] libphy: ag71xx_mdio: probed [ 1.326626] ag71xx ag71xx.0: connected to PHY at ag71xx-mdio.0:00 [uid=004dd034, driver=Atheros AR8216/AR8236/AR8316] [ 1.338112] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:RGMII [ 1.346348] NET: Registered protocol family 10 [ 1.354362] NET: Registered protocol family 17 [ 1.359005] bridge: automatic filtering via arp/ip/ip6tables has been deprecated. Update your scripts to load br_netfilter if you need this. [ 1.371938] 8021q: 802.1Q VLAN Support v1.8 [ 1.379875] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000000: 0x760c instead [ 1.389548] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000004: 0x1956 instead [ 1.399176] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000008: 0x2458 instead [ 1.408800] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000000c: 0xcbf3 instead [ 1.418427] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000010: 0xb520 instead [ 1.428055] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000014: 0xcb3e instead [ 1.437681] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000018: 0x4936 instead [ 1.447309] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0000001c: 0xe408 instead [ 1.456937] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000020: 0x311e instead [ 1.466564] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00000024: 0xb3e9 instead [ 1.476185] jffs2: Further such events for this erase block will not be printed [ 1.510801] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010000: 0xe271 instead [ 1.520434] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010004: 0xbf01 instead [ 1.530064] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010008: 0x5b24 instead [ 1.539691] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0001000c: 0x69ce instead [ 1.549318] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010010: 0x8e4d instead [ 1.558945] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010014: 0x12d5 instead [ 1.568573] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010018: 0xf6dc instead [ 1.578200] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x0001001c: 0x8069 instead [ 1.587826] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010020: 0xa343 instead [ 1.597454] jffs2: jffs2_scan_eraseblock(): Magic bitmask 0x1985 not found at 0x00010024: 0x8bb9 instead [ 1.607076] jffs2: Further such events for this erase block will not be printed _______________________________________________ Lede-dev mailing list Lede-dev@lists.infradead.org http://lists.infradead.org/mailman/listinfo/lede-dev