Great find Curt. You said they needed to be put in storage? Is there a
source for them? I can see this as an awesome way to attach a
feather-board for moldings as well as a carriage stop. Will there be
any available to you as surplus? Great find!
Mike
On 11/17/2013 12:36 PM, curt george wrote:
----- Original Message -----
*From:* curt george <mailto:[email protected]>
*To:* Legacy Google group
<mailto:[email protected]>
*Sent:* Sunday, November 17, 2013 1:31 PM
*Subject:* New jig or hold down
Hello All
I wish I could take credit for this idea. but... when I see something
that works I just want to share it.
This bracket is for a headwall unit of the hospital. (Medical gas
system, you see them behind every bed, they hook up the med. gas, like
Oxygen and Vacuum, )
AnyHow, these units are being removed, and I was told to disconnect
them and put them in storage. On these headwall unit they have
extruded alum. rails to hold equipment, this bracket is form one of
those units.
This bracket fits that Legacy's extruded alum 1/4" slot nicely.
When you loosen the bracket and turn/slight twist, it comes out
(disconects from the rail ) very easily.and if you place in the slot
and align the groves then tighten the knob it locks in place I think
its pretty neat, so I'm showing you all. Here are the pix's.
I can see this idea being used on the legacy for many hold down ideas.
After all it works. ;-)
Have a good day, All.
C.A.G.
--
You received this message because you are subscribed to the Google
Groups "Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send
an email to [email protected].
To post to this group, send email to
[email protected].
Visit this group at
http://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/groups/opt_out.
--
You received this message because you are subscribed to the Google Groups "Legacy
Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To post to this group, send email to [email protected].
Visit this group at http://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/groups/opt_out.
