Today I fitted my Rotary Table to the Revo. It does not seem to have much 
height for hollowing out bowls  ----only 21/4 "--- The other thing I have 
found ,the waste board, it's 3/4 " thick and appears to have been glued on. 
I can not see any woodscrews  holding it,,. Is that normal ?
If I put a thinner waste board I could gain another half inch.
Is there another way of lowering the table ?

You received this message because you are subscribed to the Google Groups 
"Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email 
To post to this group, send email to
Visit this group at
For more options, visit

Reply via email to