I like the idea of the v-grove bit and it is not too late to do that. I'll
ask the homeowner about how to hold the cover on. However attached,
it needs to be removable.
Thanks for the suggestions.
On Wednesday, August 9, 2017 at 10:46:05 PM UTC-5, Va Oak wrote:
> Very well done. GREAT job. Thanks for sharing.
> If you make another, give thought to flipping the board over and running a
> 60 degree V-groove bit down the centerline of each slot/vent opening. That
> will allow for a bit better airflow through the slots and reduce
> backpressure in the ducting.
> How are you securing it over the opening in the toe kick board? Rather
> than marring your beautiful work with screws, try either 3M Command Strips
> (pick one with only a few pounds of pull) or a strip of "hook & loop"
> (Velcro®) at each end.
> Just my 2 cent's worth.
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
To post to this group, send email to email@example.com.
Visit this group at https://groups.google.com/group/legacy-ornamental-mills.
For more options, visit https://groups.google.com/d/optout.