RE: Discussion of Triton router company & US & UK response to Wuhan/ChiCom virus

Wed, 22 Apr 2020 18:31:26 -0700

Bill,
For what it is worth - I understand you make the keyholes in the manner where you insert the screw heads into the hole portion and then rotate the router body  about 3/8" to seat the screws into the "straights".  If you go the  route, I suggest you take into consideration which way the router's torque will want to twist the router once you engage/feed the wood into the bit - and put the "straights" on that side of the hole.  That way if the hold down screw(s) were to loosen the motor's torque would keep the router in the straights and it would not drop out.  Just a thought.
Sounds like the other way you described - the router is sort of slid into the keyholes - with all of the keyholes' "straights" pointing/parallel in the same direction.
Thanks for the explanation of how you do it.
Mac
-----Original Message-----
>From: [email protected]
>Sent: Apr 22, 2020 9:11 PM
>To: [email protected]
>Subject: RE: Discussion of Triton router company & US & UK response to Wuhan/ChiCom virus
>
>No I cut the keyhole shaped holes into the legacy I drilled the round holes first then cut the strait part. I cut the keyholes one up and one down so you twist the triton to mount it then tighten the hand screws. I Used the baseplate to make a paper pattern to glue on the legacy to get the holes drilled in the correct position then marked and cut the straits . or if you wish and it fits do the key holes in the same direction. But before cutting anything make sure when the router is plunged in full depth the handles clear everything.
>
>Bill
>
>-----Original Message-----
>From: [email protected] On Behalf Of Patrick Salter
>Sent: Thursday, 23 April 2020 10:10 AM
>To: Legacy Ornamental Mills
>Subject: Re: Discussion of Triton router company & US & UK response to Wuhan/ChiCom virus
>
>Ok, I’ve purchased and received my new Triton TRA001!
>Now comes the next question. How did you attach yours to the legacy? Did you use the baseplate mounting system?

--
You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].
To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/1211277038.14947.1587605462003%40wamui-abby.atl.sa.earthlink.net.

Reply via email to