Re: experimenting with the rotary table

[M.W.Foscue]

To all,

You are showing us a rather neat way to create a block with a "spiral rosette" on it. 

Without the Rotary Table this would be quite a challenge of a non-plussed up LOM.

Your videos keep getting better and better.

Thanks for sharing.

Mac

---

---

-----Original Message-----
From: Tracy Smith
Sent: Nov 8, 2020 1:43 PM
To: legacy-ornamental-mills@googlegroups.com
Subject: Re: experimenting with the rotary table

I thank you as well Bill. I have plans to play with this next year. Your video is very helpful.

Tracy

---

---

On Sun, Nov 8, 2020 at 8:00 AM 'Curt George' via Legacy Ornamental Mills <legacy-ornamental-mills@googlegroups.com> wrote:

Very Nice Bill ! 

I very much like your use of the the 1,2,3 block for your spacing.

Your music is getting snapper as well. ;-)

Great job. Thank you.

C.A.G.

---

---

On Sunday, November 8, 2020, 08:17:23 AM EST, bulke...@mmnet.com.au <bulke...@mmnet.com.au> wrote:

Ok this pattern was done feeding the saddle as the rotary table is turning.

It is done with a 1inch rope moulding bit with a ½ inch pitch and 4 starts .1 cut across feeding from tail stock to head stock

2 undo leadscrew nut and move the saddle 2inches towards the tail stock re-engage the leadscrew . now cut the opposite direction for the second start headstock to tail stock 3 now dis-engage leadscrew nut and move saddle 1inch towards the tail stock re-engauge and mill the opposite direction for the third start milling from tail stock to headstock.4 Disengage leadscrew  and move the saddle 2 inches towards the tail stock re-engage and mill the final start in the opposite direction from head stock to tail stock.

See easy lol don’t worry its easier looking at the video.

https://youtu.be/2PWOSVEIreY

 

the blank is 7x7x5/8 piece of pine double sided taped to the table

 

Bill

--
You received this message because you are subscribed to the Google Groups "Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email to legacy-ornamental-mills+unsubscr...@googlegroups.com.
To view this discussion on the web visit https://groups.google.com/d/msgid/legacy-ornamental-mills/1151860404.6281.1604900724282%40wamui-charming.atl.sa.earthlink.net.