Ok, John. I have not got the hubs yet. but when I do , I will put a chuck in
the package for you as well.
C.A.G.
On Saturday, January 17, 2026 at 01:00:13 AM EST, John Von Brandt
<[email protected]> wrote:
I don’t have one, I need to pay you for the index hubs also, let me know.
Thank you.John van
On Fri, Jan 16, 2026 at 9:31 PM 'Curt George' via Legacy Ornamental Mills
<[email protected]> wrote:
Hello everyone.
I picked up 4 large jaw Jackob chucks with a MT2 adaptor on the end.
If anyone would like one of these chucks for there Legacy or lathe please let
me know.These chucks are new, but were in a flood, there is some little rust
one a few of these. Over all they are clean, with just a little TLC and some
elbow grease these chucks (with key) could serve you well for years of work.If
anyone would like one, please e-mail me [email protected] all that I am
asking is shipping + $1 dollar.
C.A.G.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion visit
https://groups.google.com/d/msgid/legacy-ornamental-mills/75380425.780797.1768627866315%40mail.yahoo.com.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion visit
https://groups.google.com/d/msgid/legacy-ornamental-mills/CAAKWGX_DPxEJDzgqLs%2BkJvU7PsYY7M%3D-0c_f4NjTKRaaXeEFmg%40mail.gmail.com.
--
You received this message because you are subscribed to the Google Groups
"Legacy Ornamental Mills" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion visit
https://groups.google.com/d/msgid/legacy-ornamental-mills/1876652617.783174.1768631283292%40mail.yahoo.com.
