I have just finished building LFS svn-20050708 and I am seeing an odd
message on the screen when I plug in my USB flash drive. The following
is what shows up on the console when I plug in the flash drive:
root# usb 1-6: new high speed USB device using ehci_hcd and address 5
scsi1: SCSI emulation for USB Mass Storage devices
Vendor: Lexar Model: JUMPDRIVE SECURE: Rev: 1000
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sda: 101784 512-byte hdwr sectors (520MB)
sda: assuming drive cache: write-through
SCSI device sda: 101784 512-byte sectors (520MB)
sda: assuming drive cache: write-through
sda: sda1
Attached scsi disk sda at scsi1, channel 0, id 0, lun 0
Attached scsi generic sg0 at scsi1, chnnel 0, lun 0, type 0
Following this message, the cursor stays locked in one position on the
screen and I do not get a screen prompt unless I hit the return key. Is
there some way to get around this problem? Thanks in advance for your help.
Ron
--
http://linuxfromscratch.org/mailman/listinfo/lfs-support
FAQ: http://www.linuxfromscratch.org/lfs/faq.html
Unsubscribe: See the above information page
