Please bottom post... G W wrote: > I went back and re-read Section 5.3. > > I deleted all my build directories and sources. > > I then went into $LFS/sources and tar xjvf gcc-4.3.2.tar.bz > > Then I cd into gcc.4.3.2 > issued the commands cp and sed, and for commands. Everything worked. > > Then I cd ..; mkdir gcc-build > I tar xjvf to mpfr-2.3.2.tar.bz2 and gmp-4.2.4.tar.bz2 and mv > mpfr-2.3.2 to gcc-4.3.2/mpfr also the same to gmp-4.2.4 This is the issue. mpfr and gmp tarballs have to be uncompresssed in the gcc-4.3.2 directory and not the gcc-build directory. > > cd gcc-build the configure worked fine, however when I run make under > gcc-build I get an error > > make: *** No targets. Stop. > I have Makefile, config.log config.status serdep.tmp in the gcc-build > directory. > > > ------------------------------------------------------------------------ > *From:* Bruce Dubbs <[email protected]> > *To:* LFS Support List <[email protected]> > *Sent:* Tuesday, August 11, 2009 9:11:03 AM > *Subject:* Re: 5.12.1 GCC-4.3.2 - Pass 2 LFS book ver 6.4 > > G W wrote: > > I better clarify where I'm at in the book. > > > > 5.12.1 GCC-4.3.2 - Pass 2 LFS book ver 6.4 > > > > after expect -c "spawn ls" > > > > I'm at: > > > > cp -v gcc/Makefile.in{,.orig} > > > > the cp command above and commands after, I don't know what directory > I'm supposed to be in?? > > Re-read Section 5.3, General Compilation Instructions. Pay special > attention > the the 2nd note labeled "Important". > > -- Bruce > -- > http://linuxfromscratch.org/mailman/listinfo/lfs-support > FAQ: http://www.linuxfromscratch.org/lfs/faq.html > Unsubscribe: See the above information page >
-- http://linuxfromscratch.org/mailman/listinfo/lfs-support FAQ: http://www.linuxfromscratch.org/lfs/faq.html Unsubscribe: See the above information page
