Direct cable from Westell DSL router to network connection on box. boot up ...
Bringing up eth0 interface ... ... sky2 0000:03:00.0: eth0: enabling interface ADDRCONF (NETDEV_UP): eth0: link is not ready Adding IPv4 address 10.0.0.2 to the eth0 interface ... [ OK ] setting up default gateway ... RTNETLINK answers: No such process ... [ FAIL ] acer2 login: ... sky2 0000:03:00.0: eth0 Link is up at 100Mbps, full duplex, flow control both ADDRCONF (NETDEV_CHANGE): eth0: link becomes ready then full stop ... I <enter> and login prompt pops up #ifconfig yields: "command not found" can ping 10.0.0.2 ping gateway 192.168.1.254 yields: Network is unreachable making and breaking network cable connection is recognized: Link is up ... Link is down .. /etc/sysconfig/network-devices/ifconfig.eth0/ipv4 ONBOOT=yes SERVICE=ipv4-static IP=10.0.0.2 GATEWAY=192.168.1.2 PREFIX=24 BROADCAST=192.168.1.255 any suggestions? thanks. r. -- http://linuxfromscratch.org/mailman/listinfo/lfs-support FAQ: http://www.linuxfromscratch.org/lfs/faq.html Unsubscribe: See the above information page
