Module: libav Branch: master Commit: 1e8561e36931d6e2c4294702907ca0beb4cba3b6
Author: Martin Storsjö <[email protected]> Committer: Martin Storsjö <[email protected]> Date: Wed May 23 16:28:25 2012 +0300 flvdec: Make sure sample_rate is set to the updated value The sample_rate variable is used for checks for audio format changes at the end of the function. This fixes cases where the sample rate was set from the codec id by flv_set_audio_codec (as for nellymoser 8 kHz/16 kHz), so the value set to last_sample_rate wasn't equal to sample_rate at this point. This caused the demuxer otherwise reports a spurious change to 5512 Hz and back to the correct one. Updating channels in the same way is only done for consistency. Currently, flv_set_audio_codec doesn't update that value. Signed-off-by: Martin Storsjö <[email protected]> --- libavformat/flvdec.c | 4 ++-- 1 files changed, 2 insertions(+), 2 deletions(-) diff --git a/libavformat/flvdec.c b/libavformat/flvdec.c index 7c4b792..b9d65a6 100644 --- a/libavformat/flvdec.c +++ b/libavformat/flvdec.c @@ -571,8 +571,8 @@ static int flv_read_packet(AVFormatContext *s, AVPacket *pkt) } if(!st->codec->codec_id){ flv_set_audio_codec(s, st, st->codec, flags & FLV_AUDIO_CODECID_MASK); - flv->last_sample_rate = st->codec->sample_rate; - flv->last_channels = st->codec->channels; + flv->last_sample_rate = sample_rate = st->codec->sample_rate; + flv->last_channels = channels = st->codec->channels; } else { AVCodecContext ctx; ctx.sample_rate = sample_rate; _______________________________________________ libav-commits mailing list [email protected] https://lists.libav.org/mailman/listinfo/libav-commits
