John Oyler wrote: >> The schematic has two LEDs hooked up to B on BDBUS6 & 7. Would it >> be difficult to make those blink? >> >> BDBUS0 & 1 are apparently IRQs, those are probably more important to me. >> >> A few other things are hooked up as well, though if I read the SX1211 data sheet correctly, those don't really interest me at all.
Maybe? See if one of the bit-bang modes on interface B helps you; you'll probably just have to try, as I've only used UART and MPSSE modes before. You previously wrote: >> To anyone that's curious, the schematic for the device in question is >> located at >> http://www.semtech.com/images/datasheet/sx1211mesh-868-915-semesh-um.pdf ...however, I did not see a schematic in there. I only saw a block diagram. Where is the schematic you're looking at? >> So far, I have this: http://pastebin.com/FsRsDaXB >> >> It compiles without error. It runs without segfaulting. But the value I read back from the register does not seem to be the value I put into it. In >> fact, reading it twice, I get back a different value each time, usually 0x00, 0xfa and 0x8a. >> >> That's better than I was doing yesterday though. Sorry, at present, I don't have time to look over the code, though someone else here might. Michael -- libftdi - see http://www.intra2net.com/en/developer/libftdi for details. To unsubscribe send a mail to [email protected]
