Hello, what information is missing so you can implement yourself?
Otherwise perhaps https://serverfault.com/questions/1107423/is-there-a-way-to-power-down-reset-a-usb-port-if-it-or-a-device-attached-has-iss helps. Regards >>>>> "Ameya" == Ameya Vikram Singh <ameya.v.si...@gmail.com> writes: Ameya> Hello Uwe Bonnes, Sorry for the late reply. For some Ameya> reason the email response to this thread is being blocked. Ameya> Would it be possible to share an example where such setup Ameya> is handled. Thanks in advance, I would like to Ameya> programmatically allow it to be in a consistent state so as Ameya> not physically keep removing and attaching the device. Ameya> On Sat, May 24, 2025 at 12:49 PM Ameya Vikram Singh Ameya> <ameya.v.si...@gmail.com> wrote: >> >> Hello, >> >> I have a FPGA development board with FT232HL chip interfaced. >> I am currently running into an issue as soon as I flash/program >> the board, the UART interface disappears. >> >> I can replicate the same behavior with the simple.c example >> under the ftdi sources. Does the library support FT232HL? Is >> there a way I can get back the UART interface connected to the >> system programmatically? I tried other examples to no success. >> Currently I have to physically remove the device and re-connect >> it to the system. >> -- >> Regards, Ameya Ameya> -- Regards, Ameya Vikram Singh Ameya> -- libftdi - see Ameya> http://www.intra2net.com/en/developer/libftdi for details. Ameya> To unsubscribe send a mail to Ameya> libftdi+unsubscr...@developer.intra2net.com -- Uwe Bonnes b...@elektron.ikp.physik.tu-darmstadt.de Institut fuer Kernphysik Schlossgartenstrasse 9 64289 Darmstadt --------- Tel. 06151 1623569 ------- Fax. 06151 1623305 --------- -- libftdi - see http://www.intra2net.com/en/developer/libftdi for details. To unsubscribe send a mail to libftdi+unsubscr...@developer.intra2net.com
