Benjamin Kirk writes: > > I haven't had a chance to look into this closely yet, but I just wanted to > > post something here so I would remember to. In writing out some relatively > > large (36x36x36 Hex27's) meshes recently, mesh.write() apparently took 1268 > > seconds!! > > I'm guessing it was an xdr file?? I've never seen anything that slow, but > certainly it is worth looking in to. I'm guessing writing a cube should be > able to reproduce the problem?
I can't reproduce this error in the CFDLab... writing the same size mesh takes about 4 seconds there. TACC has been having some troubles with their $WORK filesystem lately, so maybe that was it. It'd be nice not to have to wait 20 minutes at the end of a run for the mesh to be written, though ;-) -J ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Libmesh-devel mailing list Libmesh-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/libmesh-devel
