Hello,
I cannot install on Linux Mint 19.3. I installed as a user. It failed
and I tried again as sudo with the same result. The guide says to email
here for any help.
Steps I took, following the guide on libreplanet here
<https://libreplanet.org/wiki/Group:LibreDWG#Checking_out>.
* cd Downloads
* git clone git://git.sv.gnu.org/libredwg.git
* cd libredwg
* sh autogen.sh
That command throws the following output.
* ➜ libredwg git:(master) sh autogen.sh
+ rm -rf autom4te.cache config.status
+ test -d .git -a -f build-aux/git-version-gen
+ git fetch --tags
+ rm .tarball-version
rm: cannot remove '.tarball-version': No such file or directory
+ build-aux/git-version-gen .tarball-version
+ v=0.10.1.1198_1b2c3
+ echo 0.10.1.1198_1b2c3
+ echo 0.10.1.1198_1b2c3
+ set -e
+ autoreconf --install --symlink -I m4
autogen.sh: 24: autogen.sh: autoreconf: not found
I tried the next steps just in case the above was expected.
* ➜ libredwg git:(master) ./configure --enable-trace
zsh: no such file or directory: ./configure
➜ libredwg git:(master) make
make: *** No targets specified and no makefile found. Stop.
I stopped at this point. Is there any advice on what steps to take next
to try and install this? Any help is appreciated!
Thank you.
Kind regards,
Joe
