https://bugs.documentfoundation.org/show_bug.cgi?id=55608
--- Comment #5 from Heiko Tietze <[email protected]> ---
(In reply to Heiko Tietze from comment #4)
> * Position & Size (F4)
To disable Position and Size feels strange so I checked again what's working.
If the connector is attached to both ends nothing happens when size or position
is changed in the dialog. In any case the numbers are just adopted to the
actual connector values after moving objects around. But that's also a bug
since moving the middle point of the connector does affect the size. But not
vice versa from the dialog.
When the right side (end point) has no connection, which makes not much sense
however, changing the size in the dialog affects the connector. But not the
position. And for left (start point), nothing happens.
If the protection is active the connector cannot get detached - of course
because it has a fix position/size. And there is no chance to adjust the
connector width, which might be of interest sometimes.
Ideally, the controls in the Position and Size dialog are disabled
conditionally. That means x and y unless the left side is not connected,
width/height depending on how the connector is attached to the objects. And the
base points may be completely irrelavant. But we could also keep it as it is
because the issue has really a low importance.
tl;dr: Please keep Position and Size
--
You are receiving this mail because:
You are the assignee for the bug.
_______________________________________________
Libreoffice-bugs mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/libreoffice-bugs
