Date: Thu, 16 May 2002 09:41:18 +0800 From: Raymond <[EMAIL PROTECTED]> Subject: Re: [LIB] Poll on Linux compatible modems and NICs
At 12:20 PM 15/05/2002 -0700, you wrote: >Date: Wed, 15 May 2002 19:15:55 +0000 >From: "Matthew Hanson" <[EMAIL PROTECTED]> >Subject: Re: [LIB] Poll on Linux compatible modems and NICs >> >>I've had great success running a Bromax (a division of Kingmax) iPort >>(dongleless) 10/100 16bit PCMCIA NIC in my L50 under Red Hat Linux 6.2 >>... they even have Linux drivers for download on their website plus >>pretty good instructions on how to install them (compared to most Linux >>docs at least). The drivers aren't RedHat specific (I get the feeling it >>was written with Slackware in mind as they do make some comments about it >>in one of the docs). They're actually the reference Realtek drivers for >>the chip in that card, plus some tweaked config stuff by the Bromax >>people. Make sure you don't get the cardbus version as your L50 has no >>cardbus (the cardbus version works well under Linux on an L100 though ...). >> >>Make sure you download the latest modules for PCMCIA though otherwise >>very little tends to work ... also I can't remember if I had to patch the >>kernel twice (I installed about 3 things at once, and had to patch the >>kernel twice) ... don't try to patch the kernel twice with the same file >>or things start going pear shaped. > >Sounds good, but I'd almost prefer one of their older cards that have been >supported in Linux for a while now. I'm running Mandrake 7.1 from 2000, >and am already on shakey legs with Linux. But Neil has been working on >getting 8.1 setup on his L70, so we'll see. > >I see a guy on EBay has 4 Bromax cards, model EN10-T2T listed. They look >cheap ennough. Will check the list of Linux support cards. But if what >you say is right, it ought to be there. That or look on the Bromax website under driver downloads to see if they have a Linux driver for it. >What are you using for a modem in Linux Raymond? I'm not ... I got a Xircom Realport 56k with my L50 (the previous guy used it with the APR) but I've not used it. Even in Windows, when I'm far enough away from a network point to need to use a modem there isn't a phone line around anyway so I just use the IrDA link with my cellphone. I haven't got IrDA working under Linux yet but then again I only tried for a few minutes ... I don't use Linux on the libby often enough to justify bothering. - Raymond --- /~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~\ | | "Does fuzzy logic tickle?" | | ___ | "My HDD has no reverse. How do I backup?" | | /__/ +-------------------------------------------| | / \ a y b o t | [EMAIL PROTECTED] | | | Need help? Visit #Windows98 on DALNet! | | ICQ: 31756092 | Libretto IRC channel #Libretto on DALNet! | \~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~/ ************************************************************** http://libretto.basiclink.com - Libretto mailing list http://www.silverace.com/libretto/ - Archives -------TO UNSUBSCRIBE------- Reply to any of the list messages. The reply mail should be addressed to: [EMAIL PROTECTED] - Then replace any text on the message's subject line: cmd:unsubscribe --------TO UNSUBSCRIBE DIGEST------ Do above but with this on subject line: cmd:unsubscribe digest **************************************************************
