Hi,
I have a setup with libvirt 1.3.0 and OpenStack trunk.
Before launched the VM ip link command show the following VF mac/vlan
configuration [1]
When I launch a VM with <interface type='hostdev'> via openstack api (OpenStack
direct port)
I can see that the VF get the mac/vlan according to libvrit xml [2] and ip link
command [3], but when I delete the VM the mac/vlan config are still shown as
in [3] and not restored to [1]
Shouldn't libvirt restore the mac/vlan to [1].
The same problem exists when using <interface type='direct'> (OpenStack macvtap
port) but just for the MAC configuration of the VF.
[1] - 24: enp3s0f0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master
ovs-system state UP mode DEFAULT group default qlen 1000
link/ether e4:1d:2d:a5:f1:22 brd ff:ff:ff:ff:ff:ff
vf 0 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 1 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 2 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 3 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
[2] - <interface type='hostdev' managed='yes'>
<mac address=' fa:16:3e:11:af:fe '/>
<driver name='kvm'/>
<source>
<address type='pci' domain='0x0000' bus='0x02' slot='0x00' function='0x7'/>
</source>
<vlan>
<tag id='190'/>
</vlan>
<alias name='hostdev0'/>
<address type='pci' domain='0x0000' bus='0x00' slot='0x04' function='0x0'/>
</interface>
[3] 24: enp3s0f0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq master
ovs-system state UP mode DEFAULT group default qlen 1000
link/ether e4:1d:2d:a5:f1:22 brd ff:ff:ff:ff:ff:ff
vf 0 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 1 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 2 MAC 00:00:00:00:00:00, spoof checking off, link-state auto
vf 3 MAC fa:16:3e:11:af:fe, vlan 190, spoof checking off, link-state enable
--
libvir-list mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/libvir-list
