Good morning Trey,

> > > We might have to loosen the restrictions a bit how that information is 
> > > validated of course.
>
> > For the case of Burchert-Decker-Wattenhofer channel factories, a single 
> > channel announcement will be done for all channels within the factory, 
> > signed off by all of the participants in the channel factory, and we 
> > presume that the factory participants have validated that the money owned 
> > by who is actually owned by that who. However, each channel within the 
> > factory would then need channel updates only signed off by the two direct 
> > participants in the channel. When channels within the factory are 
> > reorganized, a new announcement will need to be done and signed off on by 
> > participants in the factory who performed the reorg.
>
> I was more talking about situations where wearen't doing
> Burchert-Decker-Wattenhofer and want (unannounced) subchannels.

Yes, but if you want to interoperate, and it is Burchert-Decker-Wattenhofer 
that gets into BOLT instead of Fulgurite, then we will need to have some way to 
interoperate a Fulgurite system as masquerading as a 
Burchert-Decker-Wattenhofer factory.

> Another idea is to have peers lie in the channel announcement which
> particular channel has the funds moving when routing a payment.

LN cannot support lying on gossip.
The issue is that if lying were possible, then it would be possible to just 
give fake channels that do not exist at all (rather than being an alias to some 
other channel) and which cannot actually route payments.
By requiring that funds be visibly locked onchain, we ensure that lying attacks 
are costly and that attackers have the option of behaving honestly (performing 
forwarding requests) and get compensated for the opportunity cost, or 
swallowing the opportunity cost.

In the future, as the LN size increases, some nodes may remove channels of low 
capacity from their local routemaps in an effort to reduce their memory 
consumption.
Larger capacity channels that are near to my node are more likely to succeed in 
forwarding, so it is better to retain them.
This implies removing low-capacity channels that are far away from my node from 
my routemap to keep my routemap size manageable.

> So
> you say "this channel has x msat capacity" and when other peers
> request to route payments through it, the parties already have agreed
> to send it through the unannounced subchannel.

This is already allowed in BOLT 1.1.
Short channel IDs are only used as a cheap (8-byte) indicator for the next node 
in the route.
If there is some private unannounced channel, or some other channel on the 
route, the forwarding node may use that if the publicly announced channel has 
insufficient capacity on the forwarding node side.

Of course, if the publicly-visible channel has low total capacity, it becomes 
unlikely to be used for forwarding by third parties.
Again, this is the tradeoff the Fulgurite user must consider.

What could be done today would be this:

1.  You and your peer lock your funds in a Fulgurite system.
2.  The Fulgurite system is split into two subchannels, one is an "ordinary" 
HTLC-only channel, the other supports HTLC and DLC.
3.  Everyone else on LN assumes your LN channel is the entire Fulgurite system 
(because that is what is committed onchain and that is what they will use).
4.  If somebody routes through you, you prefer the HTLC-only subchannel.
5.  If the HTLC-only subchannel has insufficient capacity you have two options: 
(1) swallow the cost of signing all 1 million DLC sub-contract signatures for 
every update of the HTLC, or (2) just pretend you're out of funds in the 
specified direction, regardless of the DLC-subchannel state (nobody can force 
you to use it anyway, and it is your choice to give up on the routing fees).

In the future, when Burchert-Decker-Wattenhofer gets onto BOLT:

1.  You and your peer lock your funds in a Fulgurite system.
2.  The Fulgurite system is split into two subchannels, one is an "ordinary" 
HTLC-only channel, the other supports HTLC and DLC.
3.  You and your peer pretend to create a Burchert-Decker-Wattenhofer channel 
factory that contains a single channel (the HTLC-only subchannel), with the 
rest of the funds not claimed to be used on LN.
4.  If somebody routes through you, you prefer the HTLC-only subchannel.
5.  If the HTLC-only subchannel has insufficient capacity you have two options: 
(1) swallow the cost of signing all 1 million DLC sub-contract signatures for 
every update of the HTLC, or (2) just pretend you're out of funds in the 
specified direction, regardless of the DLC-subchannel state (nobody can force 
you to use it anyway, and it is your choice to give up on the routing fees).


> It should be trivial to compose Fulgurite in
> Burchert-Decker-Wattenhofer exactly as-is, and you'd still get all the
> nice scalability benefits.

Exactly, which is why I mentioned how Burchert-Decker-Wattenhofer channel 
gossip will have to work.

Regards,
ZmnSCPxj
_______________________________________________
Lightning-dev mailing list
Lightning-dev@lists.linuxfoundation.org
https://lists.linuxfoundation.org/mailman/listinfo/lightning-dev

Reply via email to