Am 27.07.2012 11:07, schrieb Phil Holmes:
----- Original Message ----- From: "Marc Hohl" <[email protected]>
To: "Trevor Daniels" <[email protected]>
Cc: "David Kastrup" <[email protected]>; <[email protected]>
Sent: Friday, July 27, 2012 8:28 AM
Subject: Re: git push doesn't work
I have saved my public key on savannah, and the instructions say that
it will take some time before it gets activated, so I have to be
patient ...
I think it would probably be more accurate to say "may take some
time". I believe that every time I've done it, it's been instant.
Try a dry run push, and if that works, you're good to go.
I was off to play some music, but back on my computer,
git pull --verbose
still fails.
Here is what I did so far:
After Trevor's mail, I found out that I already *had*
.ssh/config|id_rsa|id_rsa.pub etc.
due to some ssh connections to other servers a friend of mine created for me
(I was sitting next to him, but apparently he can type commands faster
than I
could think, so I didn't understand what he was doing. Within seconds,
he established
some secure connections to servers, and I never cared about this).
So I copied the contents of id_rsa.pub into the right place on the
savanna web site,
and got a mail that it is accepted. Fine.
I changed the .git/config file again to match the description:
url = ssh://<username>@git.sv.gnu.org/srv/git/lilypond.git
(well, I inserted my *real* username in the line above!)
and tried the ssh connection with
git pull --verbose
but after two hours or so, I still get
Permission denied (publickey).
fatal: The remote end hung up unexpectedly
I don't understand what's wrong here.
Regards,
Marc
--
Phil Holmes
_______________________________________________
lilypond-devel mailing list
[email protected]
https://lists.gnu.org/mailman/listinfo/lilypond-devel
