As you may have noticed, the system separators is not the only thing
that's not included when you use lilypond-book. Also such aspects as the
spacing between the systems is lost. The reason is that every system is
typeset as a separate .eps file, which LaTeX treats as a separate figure.
Of course, the reason is that LaTeX should take care of the page breaking,
but there are also clear disadvantages as you have noticed.
What you can do is to define the LaTeX command \betweenLilyPondSystem
to do whatever you prefer, for example to print a system separator. I don't
have any good suggestion for what LaTeX symbol to use, for the moment,
though.
/Mats
Daniel Tonda wrote:
I don't seem to get the "//" systemSeparator when using latex and
lilypond.
I've been searching and can't find any pointers.
I put this code in a lilypond file, and when compiled by itself it
shows fine in the final pdf, but if I use it in latex I don't get the
separator.
\paper {
between-system-space = 1.5\cm
between-system-padding = #10
ragged-bottom=##f
ragged-last-bottom=##f
systemSeparatorMarkup = \slashSeparator
}
--
Daniel Tonda C.
------------------------------------------------------------------------
_______________________________________________
lilypond-user mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/lilypond-user
--
=============================================
Mats Bengtsson
Signal Processing
Signals, Sensors and Systems
Royal Institute of Technology
SE-100 44 STOCKHOLM
Sweden
Phone: (+46) 8 790 8463
Fax: (+46) 8 790 7260
Email: [EMAIL PROTECTED]
WWW: http://www.s3.kth.se/~mabe
=============================================
_______________________________________________
lilypond-user mailing list
[email protected]
http://lists.gnu.org/mailman/listinfo/lilypond-user
