El 29/11/2012 7:54, Stefan Hajnoczi escribió: > > Is the device plugged into a USB 2.0 port? >
It's connected to an external hub. I don't know if that's the reason of lsusb not showing endpoints, but when I connect the device I get this message: [ 333.697431] usb 1-2.4: new full-speed USB device number 4 using ohci_hcd [ 333.795169] usb 1-2.4: not running at top speed; connect to a high speed hub I didn't know that would alter the number of endpoints that the device shows to the system. I use a hub just because it's easier to me to reach the hub on my desk with the USB cable than the rear of my computer, but I can try to connect directly to the root hub and see if I see any changes. Thanks, L. Alberto Giménez ------------------------------------------------------------------------------ Keep yourself connected to Go Parallel: VERIFY Test and improve your parallel project with help from experts and peers. http://goparallel.sourceforge.net _______________________________________________ Line6linux-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/line6linux-devel
